
I began the slow process of putting the seed bead on each safety pin. The average was about 6 beads per safety pin. After having the beads on the pin, I strung the cord through the hole of the pin and then used the other cord for the other end of the pin.
[caption id="attachment_69" align="aligncenter" width="1000"]

Once they were all strung, I tied the ends together. The type of cord that I got was actually very hard to tie together, so I ended up placing a dab of hot glue on the knot and knotting it again and that seemed to work.

The end project! I know have my very own safety pin bracelet! :D
No comments:
Post a Comment